beautypg.com

Reprogramming a single homelink button – Dodge 2013 Charger SRT8 User Manual

Page 288

background image

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLink

௡ button you wish to pro-

gram while keeping the HomeLink

௡ indicator light in

view.

3. Continue to press and hold the HomeLink

௡ button,

while you press and release (“cycle”), your hand-held
transmitter every two seconds until HomeLink

௡ has

successfully accepted the frequency signal. The indi-
cator light will flash slowly and then rapidly when
fully trained.

4. Watch for the HomeLink

௡ indicator to change flash

rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.

5. Press and hold the programmed HomeLink

௡ button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should
activate when the HomeLink

௡ button is pressed.

• To program the two remaining HomeLink௡ buttons,

repeat each step for each remaining button. DO NOT
erase the channels.

If you unplugged the garage door opener/device for
programming, plug it back in at this time.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button until

the indicator light begins to flash after 20 seconds. Do
not release the button.

286

UNDERSTANDING THE FEATURES OF YOUR VEHICLE