beautypg.com

Dodge 2013 Charger SRT8 User Manual

Page 285

background image

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLink

௡ button you wish to pro-

gram while keeping the HomeLink

௡ indicator light in

view.

3. Simultaneously press and hold both the HomeLink

button you want to program and the hand-held trans-
mitter button.

4. Continue to hold both buttons and observe the indi-

cator light. The HomeLink

௡ indicator will flash slowly

and then rapidly after HomeLink

௡ has received the

frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.

5. At the garage door opener motor (in the garage),

locate the “LEARN” or “TRAINING” button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor.

Firmly press and release the “LEARN” or “TRAIN-
ING” button. On some garage door openers/devices
there may be a light that blinks when the garage door
opener/device is in the LEARN/TRAIN mode.

NOTE:

You have 30 seconds in which to initiate the next

step after the LEARN button has been pressed.

6. Return to the vehicle and press the programmed

HomeLink

௡ button twice (holding the button for two

seconds each time). If the garage door opener/device
activates, programming is complete.

NOTE:

If the garage door opener/device does not acti-

vate, press the button a third time (for two seconds) to
complete the training.

To program the remaining two HomeLink

௡ buttons,

repeat each step for each remaining button. DO NOT
erase the channels.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

283