D.W. Fearn VT-2 - Manual (Page 29)

D.W. FEARN
VT-1 & VT-2 Microphone Preamplifers
29
4. The output of the VT-2 should be fed directly to the recorder through the shortest
practical length of quality cable. Avoid additional cables, connectors, junction boxes,
punch blocks, or patch jacks. Use gold contact connectors if possible. Do not go
through the mixing console unless you absolutely need its features for the track you
are cutting.
5. In general, for superior sound, we recommend recording directly to the recorder with
no processing (compression, equalization, gating, etc). Any processing can be added
in the mix, if necessary. You may find that far less processing is required when using
the VT-2. If processing is required while recording the track, insert the processing
device after the VT-2 and before the recorder..
Figure 3. Typical Studio Interconnections with the VT-2
(RECOMMENDED)
(Use this configuration only
if the console functions are
absolutlely required)
(Recommended only if pro-
cessing is necessary while
cutting the track)
VT-2
VT-2
VT-2
VT-2