Items included with cisco rps, Separately orderable items, Items not included – Cisco 600W User Manual
Page 4
4
Related Hardware Installation
Additional hardware installation documents provide information about installing interconnection adapters in routers and about
rack-mounting the Cisco RPS.
You can access these document sat Cisco Product Documentation > Access Servers and Access Routers >
Cisco 600W Redundant Power System > Procedures for Spare Parts: Adapter Plates and Rack Brackets.
Release Notes
Release notes for the Cisco RPS provide information about the use of the Cisco RPS with various switches, hubs, and repeaters.
You can access this document at Cisco Product Documentation > Access Servers and Access Routers >
Cisco 600W Redundant Power System > Cisco Redundant Power System (RPS) Release Notes.
Items Included with Cisco RPS
The following items are supplied with each Cisco RPS except as noted:
•
Rack-mount brackets with screws for 19-inch rack
•
Two AC power cords
•
(With Cisco RPS -CAB model only) Four 1-to-1 DC output cables, 22-pin to 18-pin, for quasi-redundant DC power for:
–
Cisco hubs and switches
–
Cisco 2600 series routers; Cisco 3620, Cisco 3640, and Cisco 3725 routers; and Cisco 4000 series routers
•
Regulatory Compliance and Safety Information document
•
Cisco Redundant Power System Quick Start Guide (this document)
Separately Orderable Items
One or more of the following cables are required for use with the Cisco RPS -NCAB model, which ships without DC output
cables. See Table 2 on page 8 for cable usage and ordering information.
•
1-to-1 DC output cable, 22-pin to 18-pin
•
1-to-1 DC output cable, 22-pin to 8-pin
•
2-to-1 Y cable, 22-pin to 18-pin or 22-pin to 8-pin
The following optional rack-mounting brackets can be ordered separately:
•
Rack-mount brackets with screws for 23-inch and 24-inch racks
•
Rack-mount brackets with screws for telco racks
An RPS adapter module is required for each of the following Cisco devices powered by a Cisco RPS: Cisco 2500 series routers;
Cisco 2600 series routers; Cisco 4000 series routers; Cisco 3620, Cisco 3640, and Cisco 3725 routers, and Cisco MC3810 series
concentrators. See Table 1 on page 8 for adapter plate usage and ordering information.
Items Not Included
Individual items in this list may be required for your application:
•
Interface module to adapt the router or concentrator for use with the Cisco RPS
•
Four screws for installing the chassis in a rack
•
Phillips screwdriver
•
Small blade screwdriver
•
Cable ties for cable management