CLEAR Hub Express Quick Start - Manual (Page 2)

WiFi Network
Connection
(Example)
Wi-Fi Network
Name (SSID)
Signal Strength
Bar LED
Wi-Fi LED
4G LED
Power LED
Step 1: SET IT UP
• Snap the foot onto the CLEAR Hub Express
and plug in the power cord.
• The LED lights on the Signal Strenght bar will
blink sequentially an then in unison. When
the LED lights stop blinking, your CLEAR
Hub Express is ready to connect to any
Wi-fi-enabled device
QUICK TIPS
• If you are using a wireless device other than
a computer, refer to that product’s guide for
connecting to the wireless network. Be sure
to select the CLEAR WiFiRSU Network Name
and Wi-Fi Password.
• Prior to using your CLEAR® 4G internet
service, you must first activate your CLEAR
Hub through a PC or Mac® device.
Step 2: CONNECT
• Connect the Hub to your PC or Mac® device
using Wi-Fi Network Name (SSID) and Wi-Fi
Default Password printed on the back of the
Hub.
• On your computer, open the Wireless Network
Connection located at the bottom right-hand
corner of your computer screen. Select the
device Wi-Fi network name and enter the
Wi-Fi password when prompted.
UNDERSTANDING
THE LEDS:
• The flashing 4G LED
light means the device
is searching for the
CLEAR® signal.
• Once the device has
connected to the
CLEAR® signal, the 4G
LED light will remain
solid to indicate it is
connected.
• Five solid lights on the
signal strength bar
WiFi Network Connection
PC Users Open Wi-Fi Network Connection
Power Cord
Mac® Users Open Wi-Fi Network Connection
Step 3: COMPLETE ACCOUNT SET-UP
• Open your browser and go to any website and
you will be re-directed to the CLEAR website.
• Follow the online instructions to quickly
complete this important step.
• That’s it! Get online anywhere within CLEAR®
coverage.
MANAGE YOUR DEVICE
• You can manage your CLEAR Hub Express
anytime you are connected by typing
http://clearmodem or http://192.168.15.1
in your browser address bar. The default
password is “admin”.
(Example)
Wi-Fi Network
Name (SSID)