Chrysler 2013 300 SRT - Owner Manual - Manual (Page 21)

To Arm The System
Follow these steps to arm the Vehicle Security Alarm:
1. Remove the key from the ignition system (refer to
ЉStarting ProceduresЉ in ЉStarting And OperatingЉ for
further information).
• For vehicles equipped with Keyless Enter-N-Go™,
make sure the vehicle ignition system is
ЉOFFЉ.
• For vehicles not equipped with Keyless Enter-N-Go™,
make sure the vehicle ignition system is
ЉOFFЉ and the
key is physically removed from the ignition.
2. Perform one of the following methods to lock the
vehicle:
• Press LOCK on the interior power door lock switch
with the driver and/or passenger door open.
• Press the LOCK button on the exterior Passive Entry
Door Handle with a valid FOB available in the same
exterior zone (refer to
ЉKeyless Enter-N-Go™Љ in ЉThings
To Know Before Starting Your Vehicle Љ for further infor-
mation).
• Press the LOCK button on the Remote Keyless Entry
(RKE) transmitter.
To Disarm The System
The Vehicle Security Alarm can be disarmed using any of
the following methods:
• Press the UNLOCK button on the Remote Keyless
Entry (RKE) transmitter.
• Grasp the Passive Entry Unlock Door Handle if
equipped, refer to ЉKeyless Enter-N-Go™ Љ in ЉThings
To Know Before Starting Your Vehicle Љ for further
information.
• Cycle the vehicle ignition system out of the OFF
position.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19