Enhanced seat belt use reminder system (beltalert), Beltalert programming, Enhanced seat belt use reminder system – Chrysler 2010 Sebring Convertible - Owner Manual User Manual
Page 51: Beltalert, Beltalert programming
Enhanced Seat Belt Use Reminder System
(BeltAlert
ா
)
If the driver’s seat belt has not been buckled within
60 seconds of starting the vehicle and if the vehicle speed
is greater than 5 mph (8 km/h), the BeltAlert
will alert
the driver to buckle the seat belt. The driver should also
instruct all other occupants to buckle their seat belts.
Once the warning is triggered, the BeltAlert
will con-
tinue to chime and flash the Seat Belt Reminder Light for
96 seconds or until the driver’s seat belt is buckled. The
BeltAlert
will be reactivated if the driver’s seat belt is
unbuckled for more than 10 seconds and the vehicle
speed is greater than 5 mph (8 km/h).
BeltAlert
will be reactivated if the driver’s seat belt is
unbuckled for more than 10 seconds and the vehicle
speed is greater than 5 mph (8 km/h).
BeltAlert
ா
Programming
BeltAlert
can be enabled or disabled by your authorized
dealer or by performing the following steps:
NOTE:
Chrysler Group LLC does not recommend de-
activating BeltAlert
.
1. With all doors closed, and the ignition switch in any
position except ON or START, buckle the driver’s seat
belt.
2. Turn the ignition switch to the ON position, but do not
start the engine. Wait for the Seat Belt Reminder Light to
turn off and then proceed to the next step.
NOTE:
You must perform the following steps within
60 seconds of turning the ignition switch to the ON
position.
3. Unbuckle and then re-buckle the driver’s seat belt at
least three times within 10 seconds, ending with the seat
belt buckled.
50
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE