Chrysler 2005 Crossfire User Manual

Page 46

ENGINE BREAK-IN RECOMMENDATIONS
The engine in your new Crossfire does not require a long
break-in period. Following these few simple guidelines is
all that is necessary for a good break-in.

• Drive your vehicle at moderate vehicle and engine

speeds during the first 1,000 miles (1,600 km).

• Do not make any full throttle starts and avoid full

throttle acceleration.

• Use the proper transmission gear for your speed

range.

• Avoid excessive idling.
• Check the engine oil level at every fuel fill.

NOTE:

A new engine may consume some oil during the

first few thousand miles of operation. This should be
considered as a normal part of the break-in and not an
indication of a problem.

SAFETY TIPS

Exhaust Gas

WARNING!

Exhaust gases can injure or kill. They contain carbon
monoxide (CO) which is colorless and odorless.
Breathing it can make you unconscious and can
eventually poison you. To avoid breathing (CO)
follow the safety tips below.

• Do not run the engine in a closed garage or in confined

areas any longer than needed to move your vehicle in
or out of the area.

• If it is necessary to sit in a parked vehicle with the

engine running, adjust your heating or cooling con-
trols to force outside air into the vehicle. Set the blower
at high speed.

• To avoid drawing exhaust gases into the vehicle, close

the rear liftgate/decklid while driving. However, if for
some reason it must remain open, close all windows.
Adjust the heating or cooling system to force outside
air into the vehicle. Set the blower at high speed.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE