LiftMaster RSW12V Residential / Light Commercial Swing Gate Operator with Battery Backup User Manual
Quickstart, Lift master, Elite
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
QuickStart
MODEL RSW12r & RSW12Vr
for slnole gate applications
Gate Hinge Center
This QuickStart is intended to highlight a
single right-hand gate application. Each
application is unique and it is the
responsibility of the purchaser, installer and
end user to ensure that the total gate
system is installed and operated properly.
Refer to the installation manual for
complete information regarding installation,
testing and programming.
NOTE:
t№en
lifting the operator use the handle to
] Determine location for the concrete pod
according to the charts shown.
2 Install the electrical conduit and pour the
concrete pod.
3 Attoch the operator to the concrete pod.
^ Weld the gate brocket in position according
to the charts shown.
5 Weld the long arm section to the correct
length as shown in the charts.
g Weld the short arm section to the correct
length as shown in the charts.
~J
Position the operator arm onto the output
shoft so that the pin slides into the slot.
8
Adjust the nuts on the operator arm so the
operator arm fits snug on the output shaft
yet still allows enough room to swivel (the
handle must he in a 90° position).
Dimension
(A) thru (E) ore from the center of one pivot point to
' £
the center of another pivot point.
Concrete Pnd
D MINUS 10"
Suggestion: The dimensions helweeti the gate end the
concrete pad is always 10 inches less than the dimensien D.
Example: D = 42", if the dimensiens between the gate
and the concrete pad is 32".
6" ABOVE GROUND
CnuHon: if the gate is longer than 18 feet, follow
CHART At A-2.
CHART A
^
g
A B C D E i
CHART B
C D
E
—
E
Û
^ Tighten the handle by pushing it down. Test 4
to make sure the operator arm does not slip
on the output shaft.
5
46"
35.5"
29.5"
35"
11"
45"
46.75"
35.5"
33.5"
42"
11"
37"
46.75"
37"
31.5"
40"
11"
41"
47.25"
37.25"
30"
3r
11"
45"
4r
35"
29.5"
32"
11"
45"
42.5"
33"
26.5"
28.5"
11"
41"
34.5"
34.75"
29.5"
35"
14"
43"
44"
36.5"
32.5"
42"
14"
32"
44"
37"
30.5"
40"
14"
40"
45"
37"
30.5"
37"
14"
43"
44.75"
35.75"
29.5"
32"
14"
44"
41"
39"
27.5"
28.5"
14"
41"
30"
BELOW
GROUND
Lift Master
ELITE
SERIES"