Crimestopper Security Products CS-2014FM - Manual (Page 22)

PROGRAMMABLE OPTIONS
24. ULTRA-SMART TACHLESS VOLTAGE ADJUSTMENT:
This option controls the voltage reference point when using smart Tachless mode. Pressing the Lock or Unlock
buttons on the remote raises or lowers the reference level in 1% increments from 80%-%100. Button #3 resets the
unit to the factory default reference point of 90%. The default 90% setting works for most vehicles. See page 14 for
additional Ultra-Smart Tachless mode information.
25. Horn Chirps / Pulses:
This option controls the systems horn honk output. There are three selections Button 1(lock) = Horn Pulse with trip,
Button 2 (unlock) = Arm/Disarm Chirp and pulse with trip and Button 3 (trunk pop) = Arm/Disarm/Warning Chirps
and pulse with Trip (Default)
PROGRAMMING – TRANSCEIVERS & TRANSMITTERS
MAKE a NOTE of the following transmitter / transceiver compatibilities:
d
•
CS-2011RS Series IV 1 -WAY SYSTEM: CS-411TX Remotes ONLY
•
CS-2012TW1 2-Way System: CS-369LED Remote / CS-398 “Sidekick” non-paging remote
•
CS-2014FM 2-Way System: CS-599FM LCD Remote / CS-398 “Sidekick” non-paging remote
•
CS-2016FM 2-Way System: CS-699FM LCD Remote / CS-397TW “Sidekick” non-paging remote
Use the part numbers referenced above when ordering remotes. Some remotes are NOT interchangeable between systems.
When re-learning remotes or adding remotes, ALL your system’s remotes must be learned at time of programming! These
systems allow storage of up to 4 different remote codes in memory.
PROGRAMMING – TRANSCEIVERS & TRANSMITTERS
1. Open Hood (Ground the Blue wire if no hood pin is installed.)
2. Turn key to the ON position. (Doors will lock if Autolock is programmed)
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. For CS2011RS systems: Press button #1 (Lock) of the transmitter; For 2-Way paging systems and “Sidekick” remotes:
Press Buttons #1 & 2 together. You should get 2 light flashes indication the unit is waiting for a 2
nd
code, then press the
same combination of buttons on a second remote, the unit will flash 3 times indicating its waiting for the 3
r d
code and lights
will flash 4 times for 4 th code. If all 4 codes are learned, the unit will automatically exit code-learning mode, otherwise turn
key off and close hood.
NOTE: When learning 2-Way LCD or 2-Way LED remotes, wait for the confirmation beep or LCD “Antenna Icon” message
before learning the next remote.
22