Toshiba CCD Monochrome Camera IK-539A - Manual (Page 4)

This camera is a high resolution CCD MONOCHROME video camera designed for
EIA system. With the adoption of a CCD, the camera produces an image with
reduced lag, little geometric distortion and has good resistance to vibration and
mechanical shock. With those features shown below, this series is suitable for
surveillance application or as an input device for an image processing system.
(1) High resolution;
The camera can produce an image with horizontal resolution over 570 TV
lines.
(2) High sensitivity:
With minimum illumination at 0.08 lux (FI.4, 3200K) ensures this unit can
produce a good image even in very low light condition.
(3) Line-lock mode:
Based on this unique design, the image would be stable as viewed from a
video monitor controlled by a switcher, so this unit is suitable for surveillance
system application.
(4) Automatic electronic shutter (AES):
The unit automatically adjusts shutter speed according to the subject bright­
ness so that the amount of exposure is steady.
(5) Internal Sync, mode;
To set the camera at "Internal Sync, mode" will keep this camera working properly
when the frequency of the AC power is 50 Hz. Please contact TAIS Service Center
if you need to set your camera at "Internal Sync. mode".
( 1. FEATURES & DESCRIPTION: }
( 2. CAUTIONS: )
(1) In order to protect the camera, avoid placing or using it under direct sunlight, rain or
dust. (Indoor use only.)
(2) Don’t touch the CCD sensor directly with your fingers. If necessary,use soft cloth
moistened with alcohol to wipe off the dust.
(3) When the camera is not in use, keep the lens or cap being attached to protect the
CCD sensor.
(4) Connect AC 24V UL listed class 2 for power supply.
(5) Don’t drop your camera or give it a strong shock or vibration, or it will incur malfunc­
tion.
(6) Keep clean the video out connector and AC 24V input terminals.
(7) When using the camera on a tripod, fasten the tripod attachment base to the camera
using three of tapped holes and secure the tripod with the fastening attached three
screws.