beautypg.com

Pw4035 – Campbell Hausfeld PW4035 User Manual

Page 13

background image

13

PW4035

Notes

www.chpower.com

troubleshooting Chart - Gasoline Powered Pressure Washers Only

Symptom

Possible Cause(s)

Corrective Action

Pump noisy / pump runs
rough

1 . Pump drawing in air/low water

supply

2 . Valves dirty or worn
3 . Worn bearings
4 . Water too hot

1 . Ensure fittings are tight . Increase water pressure
2 . Check, clean or replace
3 . Check and replace
4 . Reduce temperature below 100ºF

Pressure washer will not
spray detergent

1 . Not using soap tip
2 . Clog, kink, or hole in detergent

suction hose

3 . Hose length too long

4 . Lance not functioning properly

1 . Install 65 degree (black) soap tip
2 . If clean, unkink or replace hose .
3. Use only hose length provided with initial purchase of

pressure washer . Detergent suction will not function if
more than one section of hose is attached to unit .

4 . Remove lance from gun . If detergent is dispensed

through gun, the lance must be replaced . If no
detergent is dispensed through gun, remove 1”
tapered detergent barb from pump . Clean the barb,
and make sure that ball and spring are properly
aligned with tapered portion of the spring facing the
ball . The ball should be on top of the spring .

This manual is related to the following products: