Introduction, Warning, Connecting the power cords – Uniden PRO 500D User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Introduction
Welcome to the world of sophisticated, state-of-the-art CB radio communi
cations. Your Un/den PRO 500D represents the most advanced mobile radio ever
designed for use in the Citizens Band Radio Service. It will operate on any of the 40
AM frequencies authorized by the Department of Communications. Your PRO
500D features a superheterodyne circuit with PHASE LOCKED LOOP techniques
to assure precise frequency control. This radio has been type accepted and certifi
ed by the DOC.
Warning
Before transmitting with your transceiver, you must obtain a Department of Com
munications (D.O.C.) Citizens Radio Licence. Obtain an application form, from
the D.O.C. Before completing the form you should read the conditions governing
the licensing and operation of the C.R.S. (D.O.C. brochure RB 14). This brochure
also can be obtained from the D.O.C. After completing the application form, mail
it with the appropriate fee to the Superintendant Regulatory of Licensing in the
State or territory in which the station will be operated.
Connecting the Power Cords
With regard to the connection of the power cords, it may be possible or desirable
to connect the red lead (for negative ground systems) or the black lead (for positive
ground systems) to the ignition switch accessory terminal so that the radio is auto
matically turned off when the ignition switch (key) is turned off.
Aiternately, the power lead may be connected to an available terminal on the fuse
block or even to a point in the wiring harness. Care must be taken, however, to
guard against a short circuit condition. When in doubt, please contact your vehi
cle dealer for specific information about your vehicle.