Uniden BEARCAT UBC 70XLT - Manual (Page 5)

Operation
To program 162.550 into channel 2:
PRESS
2 M A N
O □
PRESS 16 2. oooo
5 5 0 E
OOOO
To program 471.237 into channel 7;
PRESS
7 M A N
O □
PRESS
4 7 1 .
oooo
2 3 7 E
OOOO
Features
The following is a brief description of the
features on the UBC 70XLT.
Manual Channel Selection - To manually
select a channel press the Manual key re -
peaiedly until the desired channel number
appears in the display.
Press the channel number then, press the
Manual key. The scanner will automatically
advance to the desired channel.
Lockout - Select the channel to be skipped.
Press the Lockout key. The Lockout iii -
dicator will appear in the display whenever
that channel also appears. To take Lockout
off press the lockout key on that channel.
Priority - When it is important to keep
track of the activity on one frequency while
listening to others, the priority function
should be used. Program the important fre -
quency into channel 1. Press the Priority
key to activate the priority function. Every
2 seconds the unit will check channel 1
for activity (the priority indicator will
appear in the display). If a transmission is
found the unit will monitor that channel. If
no signal is found, the unit will remm to
the previous channel and function. Press
the Priority key again to mm off the
priority function.
Search - Use the Search mode to look for
new active frequencies within the bands of
your scanner.
Enter the lower limit frequency on the
keypad and press the Limit key:
Enter the higher limit frequency and press
the Limit key again:
These two frequencies set the range that
the unit will search. Pres.s the Search key
to start searching. If an active frequency is
found the scanner will stop to monitor the
signal. Press the Hold key to hold the
search on this frequency. Press the Hold
key again to step back to the previous
frequency or press the Limit key to step up
to the next frequency. When the signal
slops the unit will continue to search. If
the search is on hold, press the Search key
again to continue searching. Press the
Manual key to leave the search mode.
Earphone Jack
For private monitoring the UBC 70XLT
comes with an earphone. Plug the earphone
into the jack on the top of the unit. When
the earphone is cormecled the internal
speaker will be disconnected.