Uniden PC122XL - Manual (Page 2)

WELCOME '
To the world of sophisticated, microprocessor controlled AM/SSB radio communications.
Your UnidOTi PCI 22XL represents orte of the most advanced mobile type radio ever
designed for use in the Citizens Band Radio Service. It will operate on any of the 40 AM
frecfuencies and Upper and Lower Side BarxJ Frequencies designated by the Department
of Transport and Communications (DOTAC). Your PC 122 XL features a frequency
synthesizing circuit with PHASE LOCK LOOP techniques to assure precise frequency
control. This radio has been type accepted and certified by the DOTAC.
WARNING
Before transmitting with your transmitter, you must obtain a Department of Transport and
Communications Citizens Band Radio Service (CBRS) License. Obtain a brochure and
a CBRS License Application form in your nearest DOTAC office. Mail the completed
application form and the appropriate fee to the Superintendent Regulatory of Licensing
in the State of Territory in which the station wiil be operated.
MOBILE INSTALLATION
Plan the location of the radio and microphone bracket before starting installation.
Select a location that is convenient for operation and does not interfere with the
driver or passenger in the vehicle. The radio should be securely fastened to a solid
surface using the mounting bracket and self-tapping screws which are provided.
MOBILE ANTENNA
Since the maximum allowable power output of the transceiver is limited by the DOTAC,
the antenna is a very important factor affecting transmission distance. It is for this reason
that we strongly recommend that you install only a quality antenna in your new C8 racfio
system. You have purchased a superior quality transceiver. Don't diminish its perform­
ance by installing an inferior antenna.
Only a properly matched antenna system will allow maximum power transfer from the 50-
ohm transmission line to the radiating element. We recommend that you use an SWR : ■
meter when installing your antenna. Set your PCI 22XL to channel 20 and adjust to SWR ^
-1. Your UNIOEN dealer is qualified to assist you in the selection of the proper antenna ' ‘
to meet your application requirements.
For automobile installation, the whip antenna may be used with good effect. The most
efficient and practical installation is a full quarter wave whip antenna mounted on the
rear deck or fender top, midway between the rear window and bumper.
A short "loaded" whip antenna is more convenient to install on your automobile,
although the efficiency is less than a full quarter wave whip antenna.
For marine installation, consult your dealer for information regarding an adequate
grounding system and prevention of electrolysis between fittings on the hull and
water,
*
- 1 -