Uniden BC 50XL - Manual (Page 11)

TROUSLE-SHOOTiNG
If /our Uniden* Bearc^t^ 50XL is aol performing up to your expectations,
please try these simple steps If you still cannol ^ei satisfactory results after
reading this guide thoroughly and following the tr^ubie-shootng steps, you may
need to send your unit in lor service.
TROUBLE CHECK
Unit will not turn on,/no
power. 1 Batteries are not correoily installed—
check and make sure the + and -
terminals are properly aligned.
2. Batteries are dead—replace with new
ones,
3. Power is off—turn ihe volume control
on,
No reception/poor reception. 1. Antenna is not correctly installed—
check connector.
2. Environment is not suitable for scan­
ner—relocate unit and try again
3. Frequencies are not pfoperly pro­
gramed—check and reprogram.
4. Baltohes are weak or dead—replace
with new ones.
"E” appears in display 1 Programing error—check frequency and
try again.
Seep tone sounds every
15 seconds or “P” & "L’'
appear in display.
1. Batteries are low in power—replace
wiih new ones.
Keypad will not work/
can n 01 program,
1. Keypad lock is off—check and turn on.
If you determine that service is necessary, remove ihe antenna from the unit
{do not remove the batteries} and make sure it is turned off. Pack the scanner
in the original packing material and cmlon. Send it along with a brief, concise
description of the problem, your name, address, phone number and a copy
of your purchase receipt to the address listed in the warranty.