Uniden UH-O53 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To charge the nickel-cadmium batteiy:

Using the AC Adaptor/Charger
1. Plug the AC adaptor/Charger into the Charging

Jack located on top of the unit.

WARNING! Use only the supplied AC

Adaptor/Charger. Any other AC Adaptor or

external power plug having over-voltage or
reversed polarity can cause overheating or

damage to the circuitry.

2. Plug the charger into a standard AC outlet.

To fully charge the battery, leave the Adaptor/
Charger connected for between 9 and 11

hours.

Note:

Switch OFF the unit while the

battery is charging.

3. When charging is complete, disconnect the

Adaptor/Charger from the AC outlet, and from
the radio.

Mounting the Flexible Antenna

Place the end of the antenna onto the TNC

connector on top of the radio and turn clockwise

until tight.

Installing the Belt Clip

Place the Belt Clip slightly above the mounting
area on the back of the radio, and press
downward and in.

UH-053