Bose CD Player - Manual (Page 20)

Setting the alarms
Note: You can set alarms with the Wave Radio/CD on or off.
Function ■ro| panel
To enter alarm setup mode - Press and release Alarm Setup. The system is now in alarm
setup mode. ALARM 1 flashes for 10 seconds.
I
Setup
J
To select which alarm to set - While ALARM 1 is flashing, set alarm time, volume, and alarm
sound (tone •>)), radio, or CD), for Alarm 1. Press
Alarm Setup again until ALARM 2 is flashing.
While it flashes for 10 seconds, begin to set Alarm 2.
f AlBrm \
{
Setup
J
To set the alarm time - While the selected alarm is flashing, press the Time ^ or ► to set the
alarm time. The selected alarm flashes for 10 seconds.
pFlfFl
To set the alarm source - While the selected alarm is flashing, press FM, AM, or CD to select
and display that source. The tone •>)) is no longer selected.
• To reset to tone, press the source currently selected (FM, AM, or CD), which deselects it.
• When no source is displayed, the alarm is set to tone •>))■
• Setting FM or AM alarm, the station last used for this alarm is shown. Or, use
Presets or
Track/Tune <3 or |> to select a station.
• Setting CD alarm, track 1 is shown. Or, use Track/Tune <3 or I> to select a specific track or time
location for the alarm. Press CD Mode to select RANDOM or TRACK REPEAT. The CD
plays, repeating as needed, until the alarm shuts off.
• To set radio or CD followed by tone •>)), select radio or CD alarm, then press •>))
CD Stop M.
AUX is not available as an alarm source.
Track/Tune
To set the alarm volume - While the selected alarm is flashing, press Volume A or T to set
the alarm volume, from 10 to 99. The selected alarm flashes for 10 seconds.
m
( ^ )
To test the alarm volume - While the selected alarm is flashing, hold down Alarm Setup and
press Volume A or T to hear the volume setting, as demonstrated by the tone •>)) alarm only.
'Tl
To adjust snooze time - The system is set for a standard 10-minute snooze time (the number
of minutes you can delay the alarm). While the selected alarm is flashing, hold down
Sleep/Snooze
and press the Time ^ or ► to adjust the snooze time (from 1 to 30 minutes) for that alarm. The
Sleep/Snooze ^
number of minutes and Sn appear on the display to confirm your selected snooze time. You can
set a different snooze time for each alarm.
L^uiJ
To exit from alarm setup - To leave alarm setup mode, wait 10 seconds for it to disengage.
Or you can press
AUX once or Alarm Setup a few times until there is no ALARM 1 or ALARM 2
flashing.
To check the alarm setting - To display the alarm setting for 10 seconds, press and release
Alarm Setup. Press again to display one alarm setup and repeat to display the other alarm setup.
f
"A larm [
Setup
J
Reading the alarm setup displays
Figure 13
Examples of alarm setup
displays
ALARM 1
OFF •») _ •! II 1 AH
J-U U
VOLUME
E ' 5
ALARM 1 flashes. You can begin by setting the time.
ALARM I
OFF
(
1
PRESET
Setup j
©
Pressing FM selects it as the source for ALARM 1.
OFF •>))
ALARM 2
fi—' fi—a g—a VOLUME
1^*1 II
| am
u-uu cb
ALARM 2 flashes. You can begin by setting the time.
OFF
ALARM 2 1 1*1
II
1 I
U*U U TRAct 1
Pressing CD selects it as the source for ALARM 2.
20