Kenwood CAW1035-01 - Manual (Page 8)

DODGE HAM BOOB
WITH FULL CE1\TER COiXiSDLE
Disconnect the negative battery terminal
to prevent an accidental short circuit.
If vehicle has floor shifter, remove shifter
knob,
I Unsnap and remove console front top
cover (closest to the dash}. (Figure A)
t Remove two 8 mm screws from under
consofe cover (previously removed).
Remove front section of console.
(Figure B)
5 Loosen two 8 mm screws at t>ottom of
dash. Unsnap lower panel.
6 Remove (2) Phillips screws facing up on
front edge of radio/climate control panel
(Figure D)
7 Unclip and remove entire panel surrounding
radio and climate controls, including a/c
vents. (Figure £)
8 Remove (4) 7MM screws securing radio
to dash and remove radio.
9 Continue to kit assembly.