J\z\a, On your remote control, V^isign – Vizio VA26L10T User Manual
Page 2: Urlue, Where, Meets, Program your tv
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
\ j \ z \ a
WHERE V^ISIÜN MEETS 'JRLUE"
WHERE
V^ISIGN
MEETS
URLUE
Connect your TV: Choose
of the following three options to connect your TV to your Satellite/Cable Box
If your satellite or cable box has:
Connect to your TV using:
OR
RGB PC
COMPONENT
Y Pb/Cb Pr/Cr
CJ
RGB PC
AUDIO
OR
Analog HDTV
Component
Program your TV:
Programming your VA26L is a simple
TWO STEP process. All you need
is your Remote Control.
Connect your Signal Source to the
connection.
Please Note:
• Be sure the batteries in your remote are inserted correctly.
For advanced setups, refer to chapter 3 of your VA26L User Manual.
Program your Cable/Satellite Box Remote
Consult your Cable or Satellite Owner's Manual to determine if you need a 3-, 4-, or 5-digit code.
If your Cable or Satellite Box requires:
• 3-digits, please use "627" (This code usually works with DISH Network)
• 4-digits, please use "1758" or "0178"
• 5-digits, please use "11758" or "10178" (These codes usually work for DIRECTV)
OR
AV 1
VIDEO («9 L
R (
OR
NON-HDTV
AV Component
TV Tuner Setup
On your Remote Control...
n Turn on the TV, the Initial Setup screen
should appear. If this screen does not appear
see User Manual Chapter 3 for TV Tuner Setup.
B Select Language; English, Français, Español.
B Press O or O once to select Cable or Antenna.
Select Cable if you are using cable from the
wall or Air if you are using an antenna.
□ Press ^ to continue to the next screen.
Press ^ on remote to scan for channels.
Scanning for available channels could take
several minutes.
Once scanning is finished, programming is
complete.
For more detailed information see Chapter 3
of your User Manual.
(§>2008 VIZIO, Inc.