Cuisinart DCC-2400STR - Manual (Page 9)

the cycle has a flavor profile which is very
different from the flavor at the end of the
cycle. Removing a cup during the brewing
cycle will alter the flavor of the finished pot.
Once the coffee has finished brewing, stir it
before serving to blend the flavors. The
coffee at the bottom of the carafe will be
somewhat stronger than the coffee at the
top.
When the brewing cycle has been
completed, five beeps will sound. Coffee
will continue to stream from the filter for
several seconds.
After brewing, the unit will automatically
shut itself off. The thermal carafe will keep
the coffee hot for hours.
Bottom of thermal carafe is hot to touch
for several minutes after brewing.
Use caution.
The brew-through, pour-through lid allows
coffee to drip from coffeemaker through the
closed lid. When brewing is complete, the
lid seals itself so air stays out and coffee
freshness and temperature are preserved.
No need to turn or adjust the lid before
pouring.
CLEANING AND
MAINTENANCE
Always turn coffeemaker OFF and remove the
plug from the electrical outlet before cleaning.
Lift up the reservoir cover. Remove and discard
the paper filter and ground coffee. The filter
basket can be washed in warm, soapy water
and rinsed thoroughly, or cleaned in the upper
rack of the dishwasher. Dry all parts after use.
Do not put any water in the unit once the filter
basket has been removed. Wipe the area
under the filter basket with a damp cloth.
Remove the carafe from the resting plate.
Discard any remaining coffee. The carafe and lid
can be washed in warm, soapy water and rinsed
thoroughly, or placed in a dishwasher. The
carafe and carafe lid should be placed on the
upper rack only.
Do not use any scouring agents or harsh
cleansers on any part of the coffeemaker.
Never immerse base unit in water or other liquid.
To clean base, simply wipe with a clean, damp
cloth and dry before storing. Fingerprints and
other blemishes on the stainless steel housing
can be washed off with soap and water or a
nonabrasive cleaning solution. Wipe resting
plate with a clean, damp cloth. Never use rough,
abrasive materials or cleansers to clean the
resting plate. Do not dry the inside of the water
reservoir with a cloth, as lint may remain.
Decalcification
Decalcification refers to the removal of calcium
deposits which form over time on the metal
parts of the coffeemaker.
For best performance from your Brew Central
Thermal ™ Coffeemaker, decalcify the base unit
from time to time. The frequency depends upon
the hardness of your tap water and how often
you use the coffeemaker. The flashing Clean
light will indicate when you should clean your
coffeemaker.
If the Clean light begins to flash when the
coffeemaker is turned on, it is telling you that
the calcium buildup is interfering with the
functioning of your coffeemaker and the flavor
of your coffee. To clean, fill the water reservoir to
capacity with a mixture of ¹⁄³ white vinegar and
²⁄³ water. Press the Clean button. When the self
clean light glows, turn the coffeemaker on by
pressing the on/off button. The Clean light will
shine steadily. The coffeemaker is now in Clean
mode. One cycle should be sufficient to
adequately clean the coffeemaker. When the
cycle is completed and the five beeps sound,
the coffeemaker will shut off. Turn the
coffeemaker ON to see if the Clean light
continues to flash. If it does, turn it to OFF and
then repeat the cleaning procedure with a fresh
solution of vinegar and water.
If the Clean light no longer flashes, turn the
coffeemaker to OFF and then run one cycle of
fresh cold water through the unit before using
the unit again to brew coffee.
Notes on the Clean function
Pressing the Clean button cancels all other
settings. If it is pressed accidentally, press it
8