CyberPower Systems UP425 User Manual
Page 4
INSTALLING YOUR UPS SYSTEM
UNPACKING
Inspect the UPS upon receipt. The box should contain the following:
(1) UPS Unit; (1) User’s Manual for UPS; (1) Warranty Registration Card;
(1) PowerPanel
TM
Software Disk; (1) User’s Manual for PowerPanel
TM
;
(1) Serial Interface Cable (DB-9); (1) Serial-to-USB cable; (1) Telephone Cable
HARDWARE INSTALLATION GUIDE
1. Connect the equipment to your UPS outlets. Items such as copiers, laser printers,
vacuums, space heaters, or other large electrical devices should not be connected to the
UPS. Please assure that the total loads of your equipments must be less than the
maximum total power load of your UPS.
2. Connect your UPS power cord into a two-pole, three-wire
grounding receptacle only. Please avoid using extension
cords and adapter plugs. (To maintain optimal battery
charge, leave the UPS plugged in at all times.)
3. Press the UPS power button to turn it on. The “Power On” indicator will be illuminated in
“Green”.
4. Install your optional software and accessories. To use the software, simply connect the
enclosed serial interface cable to the serial port on the UPS and an open serial port on
the computer.
BASIC OPERATION
FRONT PANEL AND REAR PANEL DESCRIPTION
2