Cabela's Pro Series Vacuum Sealer 08-0601-C - Manual (Page 5)

PROTECTIVE TAPE
There is a factory installed
strip of Teflon Tape on the Vacuum Sealer.
DO NOT REMOVE THE TAPE!
TEFLON TAPE
DO NOT
REMOVE!
The Seal Bar Heating Element is covered with Teflon Tape to protect
vacuum bags during sealing (Figure 1). DO NOT remove the Teflon Tape.
See the “Maintenance Kit” section of this manual for information on replacing
the Teflon Tape, if necessary.
OVAL VACUUM CHAMBER SEALS
DO NOT REMOVE!
Figure 1
TROUBLESHOOTING
Q: Nothing happens when the Power Button is pressed!
1. Make sure that the Power Cord is not damaged
in any way.
2. Be sure that the female end of the Power Cord
is plugged completely into the Power Supply Port
of the Vacuum Sealer, and that the male end of the
Power Cord is firmly plugged into the wall outlet
(Figure F).
3. If the
Vacuum Sealer is properly plugged in,
and the Power Button still does not work, check
the Fuse, located above the Power Supply Port,
on the right side of the Vacuum Sealer. Twist the
Fuse Holder off, then look at the clear tube to see
if the Fuse is darkened. If the Fuse is darkened,
it will need to be replaced with a standard 8-Amp
Fuse.
4. If the
Fuse does not need to be replaced, you will need to be sure the electrical
wall outlet is properly working. Plug in another appliance to see if that appliance
works from the wall outlet. USE ONLY TIME-DELAY FUSES.
5. If none of the above steps remedy the situation, contact Customer Service.
Q: My Vacuum Sealer shut off and will not start again.
1. The Thermal Overload Protector may have been activated. In this case,
allow the Vacuum Sealer to cool by opening the Vacuum Lid for approximately 20
minutes. Be sure to leave the Vacuum Lid open between bag sealing.
2. Be sure that the female end of the Power Cord is plugged completely into the
Power Supply Port of the Vacuum Sealer, and that the male end of the Power Cord
is firmly plugged into the wall outlet.
3. If the
Vacuum Sealer is properly plugged in, and the Power Button still does not
work, check the Fuse, located above the Power Supply Port, on the right side of
the Vacuum Sealer. Twist the Fuse Cap off, then look at the clear tube to see if the
Fuse is darkened. If the Fuse is darkened, it will need to be replaced with a standard
8-Amp Fuse (Figure F).
4. If the Fuse does not need to be replaced, you will need to be sure the electrical
wall outlet is properly working. Plug in another appliance to see if that appliance
works from the wall outlet.
5. If none of the above steps remedy the situation, contact Customer Service.
Figure F
-20- -5-
NOTICE!!
PLEASE DO NOT DISCARD THE ORIGINAL
SHIPPING PACKAGE AND THE INNER CARTONS!
IN THE EVENT THIS UNIT MUST BE RETURNED
FOR SERVICE OR ADJUSTMENTS, THE PRODUCT
IS BEST PROTECTED DURING SHIPMENT IF THE
PRODUCT IS RETURNED IN THE
ORIGINAL SHIPPING CARTON.
WARNING!
Before cleaning, assembling or disassembling the
Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!
Check to see if the
Fuse is darkened.
I O