beautypg.com

Safety systems, Start lock-out, Overload protection – Bosch MES 1020 User Manual

Page 5: Overview, Assemble, Operating the appliance, Preparing fruit and vegetables, Extracting juice

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

A

Risk of injury!

Do not plaoe fingers in the filling shaft.

Use the supplied pusher only!

Safety systems

Start lock-out

The appliance cannot be switched on unless
-

Filter tray and lid have been attached

correctly and

-

the pulp container has been inserted
correctly.

Before using the appliance, always check

the lid lock by pulling on the filling shafti

Overload protection

If the motor switches itself off while the

appliance is being used, the overload protection
feature has been activated. Possible causes:
-

Pulp container full,

-

excessive pressure on the pusher when
adding fruit and vegetables.

In this case proceed as follows:

Switch off the appliance and pull out
the mains plug.

Release the lid and removed.

Empty the filling shaft, filter and pulp

container.

Leave the appliance to cool down for

approx. 15 minutes in order to deactivate
the overload protection.

Re-assemble the appliance. If the motor will

not

start

subsequently,

leave

the

appliance

to cool down for longer.

Overview

Please fold out the illustrated page.

1

Motor unit (with cord store)

2

Switch

open

Release lid

0/off

Switch off the appliance

1

Switch on the appliance

3

Pulp container

4

Filter tray

5

Filter

6

Lid

a

Lock

b

Release

7

Filler tray

a

For extracting juice

b

For storage

8

Pusher

9

Filling shaft

10

Juice jug (with foam separator)

Assemble

Insert the pulp container into the motor
unit

(Fig. 3)

.

First insert the filter tray with the outlet into

the motor unit

(Fig. 4)

.

Insert the filter

(Fig. 5)

. Check for damage

beforehandi

Attach the lid and press down until it clicks

into position

(Fig. 6a)

. When the lid has been

locked into position, the switch must be in

the

0/off

position.

If required, place the filler tray on the filling

shaft

(Fig. 7a)

.

To prevent froth, place juice jug with large

opening under the outlet

(Fig. 10)

.

Operating the appliance

Preparing fruit and vegetables

Warning!

Prooess ripe and unfrozen fruit and vegetables

only. Unripe fruit and vegetables will blook
the filter very quiokly.

First, wash the fruit and vegetables.

First, peel the fruit and vegetables with thick

skins (e.g. kiwi, melons, lemons, oranges,

beetroot).

Remove stones from fruit. Remove large

stalks.

Chop up large fruit and vegetables so that
they fit the filling shaft.

Do not process: Bananas, rhubarb, avocados.

Extracting juice

Place the assembled appliance on

a smooth, clean worktop.

Switch on the appliance.

When the motor is running, put fruit/
vegetables in the filling shaft.

When pushing down the fruit/vegetables,

use the pusher only

(Fig. 8)

. Never place

fingers in the filling shaft

(Fig. 9)

.

Apply only light pressure to the pusher.
This increases juice yield and protects

the appliance.

Switch off the appliance:

Do not switch off the appliance until all the

juice has run out.

Warning!

Before opening the appliance, wait until the

motor has stopped.

-

Move the switch to

0/off

.

-

Wait until the motor stops (approx.

2-3 sec.).

-

Open the cover by rotating the switch
to

open

.

en

Robert Bosch Hausgeräte GmbH

5