Before you cali – Kenmore HORNO 790.42003 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before you call for service,
review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
Before You Cali
Solutions to Common Problems
OCCURRENCE
POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and Displays
any F code error (example
F11).
Electronic control has detected a fault condition. Press
any key
to clear the
display and stop the beeping. Reprogram the oven. If a fault reoccurs, record
the fault number. Press
any key
and call Sears or another qualified servicer.
“d-o” is displayed.
The door was left open and controls set for self-cleaning cycle.
Just close the door to correct the problem.
Appliance not level.
Poor cooking results.
Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
Entire oven does not operate.
When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display will flash. The oven cannot be programmed until
the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact Sears or another qualified servicer.
Service wiring not complete. Contact Sears or anotherqualified servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting
Oven Controls
to
set the controls.
House fuse has blown orcircuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown orcircuit breaker has tripped after the oven has been
installed and previously operating. Contact Sears oranotherqualified servicer.
Oven light does not work.
Burned-out or loose bulb. Follow the instructions under
Changing Oven Light
to replace or tighten the bulb.
Fan noise during cooking
operation.
A cooling fan may automatically turn on and off to cool internal parts. This is
normal, and the fan may continue to run even after oven is turned off.
In self-clean mode, the blower in both ovens will start when using one of the
ovens.
18