Pioneer CD-ROM Drive DR-UO6S - Manual (Page 7)

DISC OPERATION
DISC SETTING METHOD
Disc setting
Insert the disc into the disc loading slot with the label facing up.
When using 8 cm discs, attach a CD adapter (available at stores) to the disc, and insert the disc into
the disc loading slot.
8 cm disc
Do not insert 8 cm discs by themselves.
When using a CD adapter, attach it properly to the disc, and check that it does not
come off to prevent damage to the disc and adapter.
Do not attempt to insert more than two discs at one time, nor insert discs during play.
Do not insert the disc with excessive force so that it bends nor attempt to insert it by force,
f \ While the unit is pulling in or ejecting discs, do not attempt to do the opposite using force
as this may cause damage to the disc or malfunction of the unit.
A
18
En
DISC OPERATION
DISC REMOVAL METHOD
• Confirm that the BUSY indicator of the drive is not lit, and then press the Eject button (^).
• Remove the disc after it has been ejected.
FORCED EJECTION METHOD IN CASE OF EMERGENCY
In the following cases, the disc can be removed using the forced ejection hole.
♦ In case of drive trouble, when the disc can not be ejected with the Eject button or by
a software command.
When the disc is to be removed while the power is switched off.
Confirm that the power supply of the computer is switched off and the disc loading is stopped. It
takes approx. 60 seconds to stop loading a disc after switching off the power supply. While this
operation, do not execute the forced ejection.
I
Use an accessory pin for emergency ejection, insert it straight into the hole for forced ejection, and
push strongly.
Fig.7
As the disc will be ejected approx. 5-10 mm from the disc loading slot, pull it out by fingers.
A ^ Do not execute the forced ejection while loading a disc, an injury or a disc damage will be
caused.
A
^ Do not place anything within 12 cm in front of the unit as this may obstruct the disc ejection
operation of the unit.
Ei