Fitting the end cap, Example of a set up with two units side by side – Pioneer PRS-X220 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fitting the end cap
1. Align the main unit and end cap
holes, and insert the screw.
Screw
Tighten the screw with a 4 mm
hexagonal wrench (not supplied).
Hexagonal wrench
Example of a set up with two units
side by side___________________
You can set up two units with the oppos
ing ends joined together.
(Refer to the illustration in step 2.)
1. Remove the bracket screw, adjust
the bracket to the desired position,
and then tighten the screw once
more to secure.
Setting up with two units joined.
If you remove the end cap badge screw,
you can adjust the badge so that the letters
are straight.
Endcap
<1