Kenmore 625.38376 - Manual (Page 33)

D
BYPASS VALVES
Bypass valve(s) should always remain in soft water
service position. Position in “bypass” only if needed for
softener repairs.
SINGLE BYPASS
Inches cm
A Salt Tank Height 40-1/4 102.2
B Resin Tank Diameter
(nominal) 9 22.9
C Resin Tank Height (nominal) 40 101.6
D Inlet-Outlet Height 41-1/2 105.4
E Overall Height 47-3/4 121.3
Fi Length 19-3/4 50.2
F2 Width 16-1/2 41.9
" Distance between inlet-outlet
centerlines 3-3/4 8.6
MODEL NO. 625.383760 - TIMER CODE H_32
WATER SUPPLY TO WATER SOFTENER
Minimum water system flow (gpm) 3
Minimum-maximum water pressure (psi) 20 - 125
Minimum-maximum water temperature (°F) 40 - 120
Maximum water hardness (gpg) 110
Maximum “clear water” iron (ppm)* 10
SALT FOR WATER SOFTENER
Type of salt needed nugget
Alternate type of salt pure, evaporated, compacted
water softener salt
gpm = gallons per minute gpg = grains per gallon
psi = pounds per square inch ppm = parts per million
' Capacity to remove clear water iron is substantiated by WQA test data. State of Wisconsin requires
additional treatment if water supply contains greater than 5 ppm clear water iron.
Questions? Call The Kenmore Water Line 1-800-426-9345
33