Kenmore 625.3882 - Manual (Page 20)

IJ.JJ J J.ÌJ.JJJ J.iJ
SECTION 4 J.ÌJ.JJ j j j,„
J.ÌJ.JJJ J.ÌJ.JJJ j.„
KNOW ABOUT YOUR WATER SOFTENER
FIG. 13
PII^EI^SIONS / specifications
fig . 14
IJ^JJJJJ^JJJJJ^JJJ
IJ^JJJJJ^JJJJJ^JJJ
lit J
1
^« t J I J IJ t J I J
11
t
m imi
t JI I
11
t JI I
ij ^ j J j KT jj J jjj^j J J
ij^jJjjj^jJjjj^jJJ
>j^j.ij.ij^j.ij.ij^j.ij
Inches CM
A Salt Tank Height 40-1/4 102.2
B Resin Tank Diameter
(nominal) 9 22.7
C Resin Tank Height
(nominal) 40 101.6
D Inlet-Outlet Height 41-1/2 105.4
E Overall Height 47-3/4 121.3
p1 Length
19-1/2 49.5
F^ Width 16-1/2 41.9
— Distance between inlet-
outlet center lines
3-3/8 8.6
BYPASS VALVES
Bypass valve(s) should always remain in soft
water service position. Position in "bypass" only
if needed for softener repairs.
3 - VALVE BYPASS
FOR SERVICE
close bypass valve
open inlet & outlet valves
FOR BYPASS
open bypass valve
close Inlet & outlet va!
Bypass
Valve
niet
Valve
MODEL NOS. 625.388200 & 625.388250 TIMER SR CODE SR27
Note: Please see the rating decal for operating capacity, salt usage and service flow rate/pressure loss
performance specifications. Performance specifications are validated by the Water Quality Association
(WQA). The rating decal is located on the rim, under the salt hole cover (see page A, inside front cover).
WATER SUPPLY TO WATER SOFTENER
Minimum water system flow (gpm)------------- 3
Minimum-Max. water pressure (psi)------------ 20-125
Minimum-Max. water temperature (°F) - 40-120
Maximum water hardness (gpg)..................... 100
Maximum “clear water” iron (ppm)------------- 6
SALT FOR WATER SOFTENER
Type of salt needed.......................................... nugget or pellet
Alternate type of salt........................................ pure, evaporated,
compacted water
softener salt
Salt storage capacity (lbs)............................... 200
4 - 1