Kenmore 630.1395 - Manual (Page 12)

RINSE AGENT
Rinse Agent
To achieve proper drying, always use a liquid rinse agent,
even if your detergent contains a rinse agent or drying
additive.
NOTE: The dishwasher indicates low rinse agent by showing
the symbol in the countdown display. Units without a
display have a Rinse Agent LED that illuminates when the
Rinse Agent is low.
NOTE: The LED will not illuminate if there is enough rinse
agent in the dishwasher.
Adding Rinse Agent
Always use Rinse Agent even if your detergent contains
rinse agent.
Add rinse agent when the LED on the control panel
illuminates.
Filling the dispenser
• Make sure the dishwasher door is completely open.
• To fill the dispenser with rinse agent, simply pour on the
“arrow”as shown below until the rinse agent is visibly
full.
Wipe up any excess rinse agent that puddles when the
dispenser reservoir is full to prevent sudsing.
After filling the rinse agent dispenser, the indicator light will
go out in a few minutes after the dishwasher door is shut.
Rinse Agent Setting
The default factory setting for the rinse agent is set
between 3 and 4.
• If you notice spots on glasses, it means you need more
rinse agent.
• If you notice streaks, it means you need less rinse agent.
To Decrease
Streaks on glasses
To Decrease
Spots on glasses
To adjust the amount of rinse agent dispensed:
• Turn the dial (in the shape of an arrow) until you reach
the desired level between 1 and 6.
12