FRIGIDAIRE 131888900 - Manual (Page 3)

15. Connect the nine pm plug removed in step K to the
connector board on the adapter harness.
16. Dress the adapter harness ttiong side of the present
washer itarness as sliowai.
17. Connect the green connector plug from the adapter
harness to the pump. Re-mstall the pump cover, jf if
was removed in step 1.3.
IS, Connect the green connector plug from the washer
harness to the connector on the adapter harness.
19. NOTE: If the service kit's door lock is already pre­
wired to the adapter harness, go to step 20. If the
service kit’s door lock is not pre-wired to the adapter
Irarness, connect the adapter harness connections to
the new door lock.
20. Matching color for color, connect the door switch
wires from the washer harness to the connectors in
tlic adapter harness,
21. Install the new door lock to the washer cabinet using
the same screws removed in step 6.
2 2
.
Using the plastic harnes.s ties, attach the adapter
harness to the washer harness. fJress the harness in
such a manner that it will not interfere with any
moving parts or cause any noise when the washer is
in operation.
Connect the washer to the electrical power source
and lest for proper operation. Close the door, place
the timer to the final spin position, and start the
timer. When the machine starts its fast ramp up to
lire higher spin speed, turn the timer off, then
quickly pull on the door handle to verify the door is
locked. If the door opens, recheck the connections in
steps 9 through 1
?..
Using the tube of adhesive, glue the bellows to the
front panel at the 2, 3, & 4 o’clock positions. Wait
about two minutes, then pull on the bellow to make
sure it is securely bonded to Ihe iront [lancl.
Install the front service panel.
O'N 131 SKSHOO S.'‘)v