beautypg.com

First steps, First steps -7 – Kenmore 25344133802 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

FIRST STEPS

то LEVEL FREEZER;

This Owner's Guide provides specific operating instructions for

your model. Use the freezer oniy as instructed in this Owner's

Guide. Before starting the freezer, follow these important first
steps.

INSTALLATION

» Choose a place that is near a grounded electrical outlet. DO

NOT use an extension cord or an adapter plug.

♦ For most efficient operation, the freezer should be located

where surrounding temperatures will not drop below 40°F (5°C)
or exceed 110°F (43°C).

♦ Allow the following clearances for ease of installation, proper

air circulation, and electrical connections:

Sides

3/8 inch

Back & Top

1 inch

♦ Do not block the toe grille on the lower front of your freezer.

Sufficient air circulation is essential for the proper operation of
your freezer.

The exterior; walis of; the fre:ezer. 'mayTjëçome .quite-w^riri

the .corVrprésSdr - works- 1.d Trarisfeir. b;e.at. ff0;rfr the.^ inside.,

"fëmps/atu res a;a much as 30'T" warmer than roont; tettiperature
ca.nTre iexpécféd:. .V .V .V .V .V .V .V .V .V .V .V .V .V .V .V .V .V .V .V .V.-

r>GOP Ohi' NiMG

NOTE: If your freezer is placed with the door hinge side against
a wall, you may have to allow additional space so the door can
be opened wider.

LEVELING

The freezer must have all bottom corners resting firmly on a solid
floor. The floor must be strong enough to support a fully loaded
freezer. It is VERY IMPORTANT for your freezer to be level in
order to function properiy. If the freezer is not leveled during
installation, the door may be misaligned and not close or sea!
properiy, causing cooling, frost or moisture problems.

After discarding crating screws and wood base, use a carpenter's

level to level the freezer from front to back. Adjust the piastic
leveling feet in front, 1/2 bubble higher, so that the door closes
easily when left halfway open.

LEVELING INSTRUCTIONS FOR ALL REFRIGERATOR /
FREEZER PAIR:

• Remove two leg levelers provided in literature bag. While unit

is lying on its back for wood skid removal, install both leg
levelers in rear of unit.

• Level door of first unit using all four levelers and slide unit into

place. Recheck for levelness and adjust if necessary.

• Measure distance from floor to bottom of door on first unit.

Adjust and level second unit so door height matches.

• Leg Level Adjustments:
• One full turn of all four leg levelers will raise door 5/32".
• One full turn of both front leg levelers will raise door 3/16"

tilt top of door back 7/16".

• One full turn of both rear leg levelers will lower door 1/32"

tilt top of door forward 7/16".

• One full turn of both side leg levelers will raise door 3/16"

tilt top of door 3/8".

• Slide second unit into place leaving a minimum gap of 3/16“

between units for door swing clearance.

• This last step may require at least one extraction of the second

unit to properiy align units in a "built-in" application.

and

and

and

To-aiiqw ;.dóor; tp.;.e!ose and-;S©ai :;pro-perty,: doLnpt; let-fopd--

paeKag-es/èkieh-d. past jthd.front of thejs-hdtve's; j j j j j j j j j j j j

This manual is related to the following products: