Kenmore ULTRASOFT 625.38818 - Manual (Page 9)

SECTION 1 WATER SOFTENER START UP
E. add salt to the storage tank
Brine (salt dissolved in water) is needed for each
and every regeneration. The water for making brine
is metered into the salt storage tank by the softener.
You must keep salt in the tank, but because the wa­
ter softener is very efficient, it is not necessary to
keep it full. Especially in humid areas, it is best to
fill the storage tank one quarter to one half full, and
to refill it more often. Salt bridging (see page 3-1) oc­
curs more often when conditions are humid.
Use NUGGET or PELLET water softener salt. DO
NOT use rock salts, as they have dirt and sediments
that will stop the softener from working.
Before adding salt, be sure the brinewell cover is in
place on the top of the brinewell.
If you choose Potassium Chloride (KCl) as a regen­
erant, following these suggestions will help give
you years of maintenance free service.
1) Place only one bag of KCl in your softener at a
time (the salt storage tank should contain no more
than 60 pounds of KCl at any one time).
2) A softener using KCl should not be placed in
areas with temperature fluctuations and high hu­
midity (KCl will harden in these environments and
may make the softener inoperable).
3) Check the brine tank and brine well (black tube in
salt storage tank) monthly. If hardening is present,
pour small amounts of warm water on hardened
areas until they loosen.
4) You must increase your hardness setting by 25%
to ensure continuous soft water as in example be­
low.
Raw Water Hardenss
(grains per gallon)
5gPg
lOgPg
ISgpg
20gPg
25gpg
30gPg
35gpg
40gPg
+ 25%
Softener setting when
using KCl
7gpg
13gpg
19gPg
25gpg
32gpg
38 gpg
44 gpg
30 gpg
WATER SOFTENING SALT WITH IRON REMOV­
ING ADDITIVES — Some salts have an additive to
help the softener handle iron in the water supply.
These salts may be used if your water supply has a
high iron content. It is recommended to use Sears
Resin Bed Cleaner 42- 34426, for periodic treatments
to keep your resin bed dean. This is available at
your local Sears store.
FIG. 4
salt
storage
tank
brinewell
Sodium information: Water softeners using sodium
chloride for regeneration add sodium to the water.
Persons who are on sodium restricted diets should
consider the added sodium as part of their overall
sodium intake. For example, if your water supply is
15 grains hard, and you drank 3 quarts of softened
water, you would consume 335 milligrams of so­
dium. That is equivalent to eating 2-1/2 slices of
white bread.
Persons who are concerned about their drinking
water should consider a Kenmore Drinking Water
System that will remove or reduce in excess of 90%
of the sodium and other drinking water contami­
nants.
1
-
6
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line