Aiid-:wafer:.0|speiiser, Mutomatìc lœ – FRIGIDAIRE Refrigerator User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Mutomatìc lœ
aiid-:Wafer:.0|speiiser- :
PureSource ™ * Ice and Water Filter (some models)
NOTE:,If, you, purchased
a
refr,igerator,with a
PureSource ™ Ice
and Water .fi Iter, please read the fo,l lowing use,
;',and careinformation. -This ice,and, water, filter-system ,'fil,ter,s -water to you,r ice maker and water dispenser. It is
located in,the upper right back corner of the fresh food compartment--.
System Startup:
Water supply does not need to be turned
cartridge has already been installed in the
to properly fill the system with water.
Small 0-nng
Filter Cartridge
Large O-nng
Filter Cup
Twist to Remove
Order new filter cartridges through the
dealer where you bought the refrigerator,
contact the
Customer Care Center
at
1-800-944-9044, or go to our web site at
order some filter cartridges when you first
install your refrigerator. Be sure to ask for
the
RG-100
PureSource™*
replacement
cartridge.
The
PureSource™
* NGRG-
2000 Ice and Water Filter
System
with
the
RG-100
cartridge
is
tested
and
certified by NSF International,
the nationally recognized and respected,
not for profit, certification organization for
public health safety. The
PureSource™*
system is tested and certified to ANSI/NSF
Standard 42. See performance data sheet
for specifications. This system should not
be used on water that is microbioiogically
unsafe or with water of unknown quality
unless the water has been adequately
disinfected before or after traveling through
the filtration system.
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum Rated Pressure -100 PSI
• Maximum Operating Temp. - 100° F
off, however, do not use ice and water dispenser while installing filter. The filter
filter housing at the factory. Refer to the
How The Water Dispenser Works
section
Changing the Filter:
Water conditions vary throughout the world, but changing the water filter every
6 - 9 months normally will ensure the highest possible water quality. The Filter
Status light will turn red after 400 gallons of water has flowed through the ice
and water dispenser {some models). Also, If the filter has been in a refrigerator
that has not been in use for awhile (during moving for example), change the
filter before reinstalling the refrigerator. The dispenser system will also operate
without filtration (with filter cartridge removed).
To change filter:
It is not necessary to turn the water supply off to change the filter.
1. Open freezer door and leave open until filter change is complete.
2.
Turn the ice maker’s power switch to the Off (“O”) position (See illustration
on page 14).
3.
Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup. This is normal.). Filter cartridge should come
down with cup. If cartridge remains in housing, pull down gently, while
twisting filter back and forth.
4.
Rinse out cup under running water.
5.
The large o-ring that seals the filter system sets in the o-ring groove
down inside the cup. Should the o-ring fall out during filter cartridge
replacement, simply place it back in the groove prior to screwing the cup
back in place. If the o-ring becomes damaged, you will need to order one
from the
Customer Care Center.
6.
Discard old filter cartridge.
7.
Remove new filter cartridge from packaging and place in cup. The end
with the small o-ring should be up, out of the cup.
8.
Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall
Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is
completely tightened with
PureSource™
logo facing outward. Do Not
Tighten Past Stop.
9.
Turn the ice maker’s power switch to the On (“I”) position.
10. Check for leaks. Open refrigerator door. Wipe any water droplets from the
filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and
reinsert the filter cartridge. Check placement of large O-ring. Reinstall
filter cup, making certain it is tightened completely.
11. To condition filter system and purge air from water line, fill a glass with
water. Continue flushing the system for approximately 3 minutes to assure
that the purest water possible is stored in the water tank.
IMPORTANT: ResettingThe.Filter Status Light {sprue,iiiodels),'-i ■ ■■ ■■■■■. ■-■
After ;,replacing .-the 'filter,'-,c,artridge,-, it, wil,l„be :necessary-,to -.press ,'the
Filter
Status reset
button located on,.the. ice■.and.waterfdispe.nser. This -.will reset
the Filter-Status iight'Push the. reset .button until the „green,, red and amber
Jights, flash.',(10.-15 seconds), Please.-refer-..to the complete dispenser
operating instructions attached-to)the'ins,id6'of.the--freezer-door. ■■■■ - ■ . - ■ ■ ■
On.,moel.els.
wit.ho.ut-a'-Rlief-Sfafiis
reset-button,
.-there
is
a
set
ot
Remi.n.der .Stickers .included, .in 'the'envelope that the.-.Us.e & Care .Manual .-
,came.'in..,-Choose. a dated sticker..that .indicates.B - ,9 ,months'{depending ,■
on .your..water, quality and ■usage),"fr,om .'the-date,-of installation. Place, the :
,stick.er.-on.)the',front,',of'■the'--flltercup,-to remind you-when it is time to
change the.filter.--'---'--'--'--'- ■
. -.
..........
* White Westinghouse uses the name CrystalCiear instead of PureSource, but they are the same filter
16