Cleaning motor safety filter, Cleaning exterior and attachments, Storing your vacuum – Kenmore 3828FI2852V User Manual
Page 10: Warning, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEANING MOTOR SAFETY FILTER
WARNING
Electrical Shock Hazard
Do not operate the cleaner without the
motor safety fiiter. Be sure the filter is dry
and properly installed to prevent motor
failure and/or electrical shock.
Check motor safety filter occasionally
and clean when dirty.
1. Unplug cord from wall outlet and lift
canister hood.
2. Pull out the dust bin and motor safety
3. Wash filter in warm soapy water, rinse,
then dry. Do not clean in dishwasher or
install while damp.
4. Insert motor safety filter back into canister.
5. Place the dust bin and close the hood.
CLEANING EXTERIOR AND ATTACHMENTS
1. Unplug cord from wall outlet. DO NOT drip
water on cleaner.
2. Clean vacuum exterior using a clean, soft
cloth that has been dipped in clean water,
then wrung out. Wipe dry after cleaning.
NOTE: Regular cleaning helps to reduce static
electricity and dust buildup on outer surfaces of
cleaner and attachments.
CAUTION
DO NOT use attachments if they are wet.
Damage to motor may occur.
Attachments used in dirty areas, such as
under a refrigerator, should not be used
on other surfaces until they are washed
since they could leave marks.
STORING YOUR VACUUM
When not in use, store the cleaner in upright
position by inserting nozzle clip into storage clip
in canister body as shown.
-10-