Materials needed, Basic tools, Materials and basic tools needed – Kenmore Power Miser 12 153.320493 HT User Manual
Page 5: Additional tools needed when sweat soldering
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To
simplify
the
installation
Sears
has
available
the
installation
parts shown below. You may or may not need all of these materi
als, depending on your type of installation.
Electric
Water Heater
Installation
Kit
ii
ML
it
-ftf-
e
WATER HEATER HEAT TRAPS
HELP REDUCE HEAT LOSS DUE
TO THERMAL SYPHONING
WATER HEATER INSTALLA
TION KIT WITH FLEXIBLE
CONNECTORS FOR 3/4" OR
I/Z" THREADED OR COPPER
LUMBING
DRAIN PANS AVAILABLE IN 20"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18" OR LESS,
24" DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 22" OR LESS
AND AVAILABLE IN 28" DIAMETER
FOR WATER HEATERS HAVING A
DIAMETER 26" OR LESS
EXPANSION TANKS FOR THERMAL
EXPANSION CONDITIONS AVAILABLE
IN 2 GALLON AND 5 GALLON CAPACITY
THROUGH LOCAL SEARS SERVICE
CENTERS
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Seats store.
Pipe Wrench (2)
Screwdriver
6 Foot Tape or Foiding Rule
Garden Hose
Drili
Pipe Dope or Teflon Tape
6 FOOT TAPE
GARDEN HOSE
SLOT-HEAD SCREW DRIVER
PIPE
WRENCH
PHILLIPS SCREWDRIVER
P.PI 4.0*1
PIPE DOPE
(SQUEEZE TUBE)
ROLL OF TEFLON TAPE
(Use only on water connections)
ADDITIONAL TOOLS NEEDED
WHEN SWEAT SOLDERING
Tubing Cutters or Hacksaw
Propane Torch
Soft Soider
Solder Flux
Emery Cloth
Wire Brushes
HACKSAW
\
A
3/4" WIRE BRUSH
1/2" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
ROLL OF EMERY
CLOTH
SOLDER
FLUX
PROPANE TORCH
nà-g
TUBING
CUTTER