Basic tools, Additional tools needed when sweat soldering, Materials and basic tools needed – Kenmore 153.31702 User Manual

Page 5: Materials needed

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Materials and Basic Tools Needed

Materials Needed

To simplify the installation Sears has available the installation
parts shown below. You may or may not need all of these materi
als, depending on your type of installation.

'■

!§■

■■

li'' ■

WATER HEATER INSTALLA
TION KIT WITH FLEXIBLE
CONNECTORS FOR 3/4" OR

1/2" THREADED OR COPPER

PLUMBING

EXPANSION TANKS FOR THERMAL
EXPANSION CONDITIONS AVAILABLE
IN 2 GALLON CAPACITY THROUGH
LOCAL SEARS SERVICE CENTERS

DRAIN PANS AVAILABLE IN 20"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER IS" OR LESS,
24" DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 22"
OR LESS AND AVAILABLE IN 28"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 26" OR LESS

Basic Tools

You may or may not need all of these tools, depending on your

type of installation. These tools can be purchased at your local
Sears store.

•

• Pipe Wrench (2) 14"
• Screwdriver
•

Foot Tape or Folding Rule

• Garden Hose
• Drill
• Pipe Dope or Teflon Tape

6 FOOT TAPE

GARDEN HOSE

SLOT-HEAD SCREWDRIVER

PIPE

WRENCH

PHILLIPS SCREWDRIVER

PIPE DOPE (SQUEEZE TUBE)

i-oll of teflon t^e

DRILL

(Use only on water connections)

ADDITIONAL TOOLS NEEDED WHEN

SWEAT SOLDERING

• Tubing Cutters or Hacksaw
• Propane Torch
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes

HACKSAW

3/4” WIRE BRUSH

1/2" WIRE BRUSH

ROLL OF LEAD FREE

SOFT SOLDER

ROLL OF EMERY

CLOTH

SOLDER

FLUX

PROPANE TORCH

TUBING

CUTTER