Kenmore 153.31702 - Manual (Page 15)

Service and Adjustment (cont’d)
Element Cleaning/
Replacement
To remove the element from your tank in order to clean or
replace it;
1. Before beginning turn “OFF” the electric power supply to the
water heater.
A WARNING
HAZARD OF ELECTRICAL SHOCK! Before
removing any access panels or servicing the water
heater, make sure the electrical supply to the water
heater is turned "OFF”. Failure to do this could
result
in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
2. I'urn off the water supply to the water heater at the water
shutoff valve or water meter.
3. Attach a hose to the water heater drain valve and put the
other end in a floor drain or outdoors. Open the water heater
drain valve. Open a nearby hot water faucet which will relieve
pressure in the water heater and speed draining.
A WARNING
The water passing out of the drain valve may be
extremely hot. To avoid being scalded, make sure all
connections are tight and that the water flow is
directed away from any person.
4. Remove the two screws securing the access panel, and remove
panel.
5- Open the flap of insulation to expose the opening.
6. Lift out the tab as shown to unclip the terminal cover from
the thermostat. The terminal cover can now be removed
from the thermostat.
15