Kenmore 625.38575 - Manual (Page 4)

_ i"Q
install the ro system
“
The RO assembly and storage tank is designed for
installation under the sink, usually in the kitchen or
bathroom. The RO assembly mounts on a wall sur­
face, or can lay on the cabinet floor next to the storage
tank. Hanger washers and wood screws are included
for cabinet wall mounting. The RO product water
faucet installs on the sink, or on the countertop next
to the sink (page 6).
Note: Tubing lengths allow for the removal of the as­
sembly from the hanger washers for servicing. If tub­
ing lengths are shortened for neater appearance, it
may be necessary to keep the assembly on the hanger
washers for service.
You can also locate the RO assembly and storage tank
in any remote location from the faucet, observing
safety guides on page 2. You do need a nearby water
source and drain point (see page 17).
Water Supply: To provide supply water to the RO
system inlet use the included feed supply fitting or
install pipe fittings for tubing connection, as typical­
ly shown on page 5.
Drain Point: A suitable drain point is needed for re­
ject water from the RO membrane. A floor drain,
laundry tub, standpipe, sump, etc., is preferred, as
shown in the remote locations drawing, page 17. A
sink p-trap drain adaptor is included to install where
codes permit, as an optional drain point (page 6).
- TOOLS AND MATERIALS NEEDED -
^ adjustable wrench, standard pliers, and larger ^ electric drill and bits, if hole is needed for the RO
adjustable jaw pliers or pipe wrench to fit sink drain
faucet, page 6.
^ slotted and Phillips head screwdrivers
► plumbers putty
- 6 STEPS TO INSTALL -
STEP 1: - Install Cold Water Supply fittings
STEP 2: - Install Drain Adapter
STEP 3: - Install Faucet
STEP 4: - Install RO Assembly
STEP 5: - Install Storage Tank, Make Remaining Tub­
ing Connections
STEP 6: - Sanitizing, Pressure Testing, Purging
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line