Tïx>ubleshooting guide, Troubleshooting guide, Dishwasher is not operating properiy – Kenmore 15808 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tïx>ubleshooting Guide
Dishwasher is not operating properiy
PROBLEM ...
CAUSE...
SOLUTION ...
Dishwasher does not
run or stops during
a cycie
Door not closed
Wrong cycle selected
No or improper power
supplied to dishwasher
Make sure door is closed and securely latched.
Refer to the “Cycles” section, page 12-13.
Check to see if household fuse or circuit breaker is
blown or tripped.
Motor stopped due to
overload
Motor will automatically reset itself within a few minutes.
If it does not restart, call for service.
No water supplied to
dishwasher
Check to see if shut-off valve (if installed) is turned on.
Dishwasher will
not fill
Overfill protector stuck
Check to see if the overfill protector moves up and down
freely. Press down to release.
Dishwasher seems
to run too long
Water supplied to dishwasher
is not hot enough
It is normal for the dishwasher to run longer while heating
water. Refer to the “Water temperature tips” section,
page 11.
•A delay will occur in the main wash if the Water Heat
option is selected.
• Three delays will occur if the Pots & Pans cycle is
selected.
•The final rinse will automatically delay until the water
temperature reaches 135°F (57°C).
Water remains
In dishwasher
Cycle not finished
Wait for the cycle to complete.
Detergent remains in
covered section of
dispenser
Cycle not finished
Detergent has lumps
Bottom rack in backwards
Wait for the cycle to complete.
Replace with dry, lump-free detergent.
Refer to the “Parts and Features" section, page 3 and
reinstall rack if necessary.
White residue ap
pears on front
of access panel
Too much detergent
was used
Brand of detergent
developing excess foam
Refer to the “Using the detergent dispenser” section,
page 10.
Try a different brand to reduce foaming and eliminate
buildup.
Odor in the
dishwasher
Dishes oniy washed every
2-3 days
Run a Quick Rinse cycle at least once or twice a day
until full load is accumulated.
Plastic smell of new dishwasher
Run a vinegar rinse, as described on the next page.
Condensation on
kitchen counter
Excessive moisture from vent in
dishwasher console
Dishwasher console should be aligned with countertop.
Refer to Installation Instructions for more information.
Food soil left
Improper loading
Refer to the “Loading Your Dishwasher” section.
on dishes
pages 7-9.
Water temperature is too low
Use the Water Heat option. If needed, turn home water
heater up to ensure water entering dishwasher is 120°F
(49°C) minimum. Refer to the “Water temperature tips”
section, page 11.
Use of incorrect, too little.
Use recommended dishwasher detergents only. Refer
or ineffective detergent
to the “Using the detergent dispenser” section, page 10.
Never use less than one tablespoon per load. Detergent
must be fresh to be effective. Always store detergent in
a cool, dry area.
18