Materials and tools needed, Fig. 1, Typical undersink installation – Kenmore 625.384600 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PARTS OF THE SYSTEM

MATERIALS AND TOOLS NEEDED

y* filter system assembly including mounting brack

et and screws

y water supply fitting
y filtered water faucet for sink or countertop mount

ing
y tubing to make all needed connections

• plumbers putty

• slotted and Phillips screwdrivers

• pliers and adjustable jaw wrench

• tubing cutter

• sandpaper or emery cloth

• electric drill and 3 / 4" drill bit if mounting hole is

needed for the faucet, see page 6

CAUTION; To avoid damaging the sink, consult a

qualified plumber or installer for drilling procedures

in porcelain or stainless steel.

FIG. 1

TYPICAL UNDERSINK INSTALLATION

DiSn _

tittered water
faucet

SINK

HOT

COLD

shutoff valve
Note: To change the fil

ter cartridge, you must

turn off the water and re
lease pressure by open
ing the faucet. A nearby
shutoff valve is conve
nient. Most sinks al
ready

have

shutoff

valves on the supply
pipes.

WATER

OUT

supply fitting

Filter II

Filter I

Note: Be sure to allow a minimum space of 1-1/2” under
the system for removing the sumps, to change the
cartridges.