FRIGIDAIRE FFPS4533QM User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Reversing the dear swing should be performed by a
qualified person. Before you begin, ensure that the
appliance is unplugged and empty. Adjust the two
leveling legs on the front of the refrigerator to their
highest level by turning counter clockwise. It is
recommended that two (2) people perform this task.
TOOLS REQUIRED
• Phillips Head Screwdriver
• Flat biaded screwdriver
Note: To remove the door it is necessary to lilt the
appliance backward.
You should rest the refrigerator against a stable, solid
object and place something under the rear rollers so
that It will not slip doing the door reversal process.
DO NOT lay the appliance completely flat as this may
damage the coolant system.
First Step
Fourth Step
Swap over
Remove the bottom hinge by
removing the leveling leg and
screws on the bottom of the
refrigerator cabinet. To reattach
the hinge on the opposite side
of the cabinet, first remove the
leveling leg. Reattach the hinge
using the screws that were
previously removed. Reattach
both leveling legs.
Fifth Step
f
Ч
/
Freezer
door
Refrigerator
door
Second Step
Lift the freezer door up and
away from the appliance.
Sixth Step
Insert
middle
hinge
Pull
I up
Replaça
door
Remove the pin assembly
from the bottom of the freezer
and refrigerator doors. On
the opposite side, attach the
replacement pin assembly
(located In the plastic hag with
the Use and Care Manual) with
a screwdriver. Note:
You must re-use the screw
from the pin assembly that
is removed In this step when
attaching the new assembly.
Place the retrigerator door on the
bottom hinge. Ensure the door is
aligned horizontally and vertically,
and that the gasket seals on all
sides before attaching the middle
hinge. Attach the middle hinge
using a screwdriver.
Third Step
Remove the screws from the middle hinge.
Lift the refrigerator door up and away from the
appliance.
Seventh Step
Dlsmantlo
Place the freezer door on the
middle hinge. Ensure that the
door is aligned horizontally and
vertically, and thatthe gasket
seals on all sides before attaching
the top hinge. Attach the top hinge
and replace the hinge cover.
IMPORTANT:
Double check that both doors are aligned correctly and
gaskets are sealed on all sides. If necessary re-adJust
the leveling legs.