To replace belt, Light bulb changing – Kenmore 116.28615 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt path.
NOTE: See
PARTS AND
FEATURES
for Belt num
ber.
Motor
Drive
Belt
Path
Agitator End Cap
2. Place agitator
assembly back into
PowerMate.
3. Line up
front of
cover and
base, Rest
cover on
front edge
of base as
shown.
Cover
Side
Latch
Rear
Laiches
Base
4. Rotate cover
back,. Press
cover firmly until
side and rear
latches snap
into place.
Make sure there is no gap between the
cover and base.
5. Turn PowerMate upside down and
replace two |2) cover screws.
LIGHT BULB CHANGING
1. Remove PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
2. Push in and turn
bulb counterclock
wise, then pull out
to remove.
3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts{ 130 Volts).
4. Reinstall PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
NOTE: See PARTS AND FEATURES for
bulb number.
18