Kenmore 580.53701 - Manual (Page 8)

CLEANING THE WATER BUCKET
1. Pull out the bucket cover.
• Place thumb at position 0 and
pun outward. Race other hand at
posib’ontDandpuHup.
2. Clean inside of bucket wlh
brush or dampened doth.
* We recommend using a mild
detergent solution.
3. Replace the bucket cover.
• Make sure tabs 0 and 0 are
placed as shown.
Brush or
Tab® Tab©
REMOVING AND EMPTYING THE WATER BUCKET
1. Empty the bucket manually.
When the bucket is full, pul) out
and empty It into a large sink or tub
and then replace it properly.
• Do not overtighten the hose when
connecting it to the bucket. Use a
rubber washer and tighten by
hand firmly without stripping tfie
plastic threads.
< Be careful while takmg out the
bucket as tt can cause damage.
• Please do not shake strongly
when you carry the budget. It can
cause to breakage of the handle
or bucket cover.
It is advisable to carry the bucket
by supporting it from the bottom.
2. Attach a len
hose connei
of garden hose to №e threaded bucket drain
ion to carry water to the drain.
The budget has a threaded hose
connection which can be left open.
Drill a 1/4" (6.4 mm) hole in the
center of the hose connection.
Once opened, the hose connection
will continually drain water from the
bucket.
• The nozde cannot be fixed after
pundure. Use an ordinary garden
hose cap to redóse if necessary.
• When ins^ng the bud^t into the
unit. Ii№ng up the bottom tip of the
bucket lightly makes insertion
easily.
' When being attached to №e
bucket drain hose connection, be
sure the hose doesn’t kink or
bend. It should He flat from the
dehumidifier to the drain.
' The hose attachment wi(1 accept a
standard garden hose filling. You
can attach a screw-on cap to use
the bucket wittiout a hose.
-
8
-