Installing your dehumidifier, Defrost control, Choosing the proper location – Kenmore 580.53701 User Manual
Page 7: Automatic shut off, Defrost contiol
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

INSTALLING YOUR DEHUMIDIFIER
' Install the dehumidifier on a level floor strong enough to
support the unit with a full bucket of water.
' For best performance, allow at least 12-18 inches of air
space on all sides of the unit for good air drculation.
• Keep all outside doors, windows, and other openings closed
when operating the dehumidifier. Humid outdoor air will add
to the unifs work load,
• Install your dehumidifier in an area where the temperature
will not fall below 65®F (18“C), At temperatures below this,
the coils can become covered with frost, whidi may reduce
dehumidifying perfomnance.
DEFROST CONTROL
When the defrost control senses frost build-up on the
evaporator coil, it will automatically shut off the compressor.
The fan will continue to run to draw air across the coil and
melt the frost. When the coil is defrosted, the compressor will
automatically restart and dehumidifying resume.
The defrost feature in the 580.53701 model will
continuously cycle up to temperature of 43°F (S^C).
CHOOSING THE PROPER LOCATION
> Use the dehumidifier in a basement to help
prevent rrx>isture damage.
' Use the dehumidifier in oooldng, laundry,
bathing, and dishwashing areas that have
excessive moisture.
^ Use Oie dehumidifier to prevent moisture
damage anywhere books or valuables are
stored.
AUTOMATIC SHUT OFF
When the bucket is full, or when the bucket is not in the proper position, the Bucket Full light turns on
and the unit automatically shute off.
Also, when bucket is out of position, the unit will beep 3 times.
The bucket must be replaced in the proper position for the dehumidiHer to work. The light will
be on mid the dehumidifim will not nin if the bucket is not ki the proper position.
-
7
-