Kenmore 580.75281 - Manual (Page 11)

OPERATION
CONTROL PANEL
FAN SPEED
• Every time you push this button, it advances the setting as follows: {High ' Low > Med > High}
J
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of 1°F.
• The setting appears in the display.
■POWER
• To turn the air conditioner ON, push the button.
To turn the air conditioner OFF, push
the button again.
-TIMER
• This button takes priority over any other button.
- SHUT-OFF TIME * When you first turn it on, the air conditioner is on
• You will usually use shut-off time while you sleep.
® /\I ito
• If unit is running, usetimer to set number of hours until shut-off. , , ............................. .
. For your sleeping comfort, once timer is set, the thmperature '
’ ■ I 'I* .1 ■ at the previous setting once power returns,
setting will raige 2 V after 30mm and once again after another 30min. ^ r
• Push timer button to advance setting from 1 Hour..... ► 2Hour.. ...*12 Hours maximum.
-START TIME
• If unit is oft, Timer sets number of hours before unit starts.
• Push timer button to advance setting from 1 Hour »2Hour.......... >12 Hours maximum.
MODE
- Push this button to shift mode of operation from cool................. ► energy saver....► fan.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on so that the unit can check the room air to determine if
cooling is needed.
In failure of electric power, the unit runs as previous setting operation.
HORIZONTAL AIR DIRECTION CONTROL
The horizontal air direction is adjusted by moving
the vertical louvers right and left with your
fingertips. {FIG. 24)
VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
horizontal louvers up and down with your fingertips.
(FIG. 25)