Let’s keep going.. .it’s getting easier, we hope, Next, let’s attach the upper mounting assembly, Apply putty to the sink sleeve – Kenmore 17568563 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

LET’S KEEP GOING.. .IT’S GETTING EASIER, WE HOPE.

NOW WE’RE GETTING INTO

THE ACTUAL INSTALLATION.

SEPARATE THE PARTS IN

THE MOUNTING ASSEMBLY.

First, remove the mounting assembiy
from the iower mounting ring. Holding
the mounting assembly with one hand,
insert your wrenchette or screwdriver
into one of the lugs ol the tower moun
ting ring and turn it to the left
(counterclockwise)

with

your

other

hand.

Then loosen the screws on the moun
ting assembly until they are just level
with the surface ol the mounting ring,

Mounting Ririg / J

Snap /

Groove

Sirie Sleeve

Mrxm linn

D. 1 K.—

Now, use a screwdriver to pry off the
snap ring.

The assembly will now come apart. Set

it aside and move to the next step.

NEXT, LET’S ATTACH THE

UPPER MOUNTING

ASSEMBLY.

First, worldng from under the sink, slip the
fiber gasket

and next the metai back-up

ring

(flat side up) up and over the sink

sieeve.

Hold the fiber gasket and metal back- up
ring In place with one hand and place
the mounting ring with its three screws onto
the sink sieeve.

Now. push the fiber gasket, metal back-up
ring and the mounling mg further up on the
sink sleeve. Side the snap ring onto the sink
sleeve until it pops into place iri the groove

on the sleeve.

Tighten the three mounting screws with
your screwdriver until the whole mounting
^sembly Is seated evenly and tightly
against the sink.

APPLY PUTTY TO THE

SINK SLEEVE.

Make a fat snake ol “plumber’s"
putty by rolling it between your
hands.

Apply this roil under the rim of the
sink sleeve.

Then, place the sink sleeve into the
sink drain hole and push down
gently bul firmly to make sure it sits
eveniy in the putty.

TURN YOUR NEW

iVg n DISPOSER UPSIDE

■m

DOWN AND REMOVE

■

THE ELECTRICAL

PLATE FROM THE DISPOSER SO
YOU CAN SEE THE WIRING AND

THE GROUND SCREW. THE BOTTOM

OF YOUR DISPOSER WILL LOOK
LIKE THE ONES SHOWN IN ‘A’ OR ‘B’.

(Star! here if you are replacing a disposer with the same mounting.)

Remove the electrical piale from the bottom of the disposer and puil out the
black and white electrical wires. The green ground screw is also under this
píate.

GREEN GROUND

RESET SCB|

Bl/TTCW

BLACK AND

WHiTE WfRES

BUJLT-(N

CABLE CLAWP