Using the air conditioner, Operation, Features using the air conditioner a – Kenmore 580.72053 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

FEATURES

USING THE AIR CONDITIONER

warmng

I To reduce the risk of fire, eiectric

shock, or injury to persons, read the important

SAFETY instructions section before operating this

appliance.

To begin operating the air conditioner after

installation, follow these steps:

1. Plug in the air conditioner. {To prevent electrical

hazards, do not use an extension cord or an

adapter plug.)

2. Set the TEMP control to the coolest setting.

3. Set the MODE control at the highest COOL level.

4. Adjust the louvers for comfortable air flow.

5. Once the room has cooled, adjust the TEMP and

MODE control to the setting you find most

comfortable.

NOTE : If the air conditioner is turned off, wait 3
minutes before restarting. This allows pressure
inside the compressor to equalize. Failure to wait 3

minutes before restarting may cause inefficient

operation.

If you move the TEMP control to a warmer, then

immediately back to a cooler setting, the unit will
shut off.

Wait 3 minutes before restarting.

Refer to the AIR CONDITIONER FEATURES

section for other settings.(See page 10)

1. Cabinet

2. Horizontal Air Direction Control Tab

3. Cool Air Discharge

4. Inlet Grille

5. Air Filter

6. Control Knobs

7. Upper Guide

. Curtain