Kenmore 580.72053 - Manual (Page 6)

INSTALLATION
INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed.
HOW TO INSTALL
GUIDE PANELS
Insert the guide panels into the guides of the air
conditioner. Fasten the curtains to the unit with
screws (ITEM A), as shown in FIG. 2.
SEAL STRIP
Cut the adhesive-backed seal strip (ITEM D) to the
window width.
Remove the backing from the seal strip and attach the
seal strip to the underside of the bottom window. (FIG. 3)
SEAL STRIP
(ITEM D)
F1G.3
LOCATING UNIT IN WINDOW
Open the window and mark center line with pencil
on the center of the inner sill, as shown in FIG. 4.
INNER SILL
CENTER LINE
ATTACH L BRACKET
Install the L brackets on the outer sill with the short
side of the bracket against the back of the inner
sill. Install one L bracket 8" to each side of center
line. See FIG. 5.
The bracket helps to hold unit securely in place.
Be sure to place bracket edge flush against back
of inner sill. See FIG. 5.
If air conditioner is blockde by storm window
frame, see step 9.
DRAINAGE
First, be sure to insert the drain pipe into base pan
before installation.
The air conditioner must be installed with a slight tilt
downward for proper water drainage. The air
conditioner will drain the excess condensed water
through the drain pipe.
DRAIN CAP
DRAIN PIPE
DRAIN PIPE
N-
BASE PAN REAR
BASE PAN BOTTOM
FIG. 6