GE DBSR453 - Manual (Page 9)

About reversing the door.
ge.com
Reversing the Door
Tools needed:
m Standardi2 ■ Tape-tipped
Phillips screwdriver putty knife
1^ Open the door and remove the filler plugs opposite the hinges. With the door
^^ completely open, remove the bottom screw from each hinge on the diyer face.
Insert these screws about halfway into the TOP holes, for each hinge, on the opposite
side (where you removed the tiller plugs). Apply fnm pressure to get the screw started
in new holes.
cS'
I
a
I
C/J
ra l.oosen top screw from each hinge on the diyer face half wa)’. With one hand holding
'—' the top of the door and the other hand holding the bottom, remove the door from
the dner b\' lifting it UP and OUT.
ra Rotate the door 180°. Insert, it on the opposite side of the opening by moving the door
'—'
IN and DOMW until the top hinge and the bottom hinge are resting on the top screws
inserted in step 1.
Remove the remaining screws from the side of the opening from which the door
'—' was removed. With these screws, secure each hinge at the bottom. Tighten the
Civo toj> screws of each hinge. Reinsert the plastic jrlugs on the side from which
the door was removed.
c
C3-
c5*
a
Q
O
t
■S'
s»
g
I
Si
?
a
5